Jump to:



General Instructions

Cleaning Solution Instructions

Chip Resetter

Tools required:

Buy this cartridge rather than refill it.
  1. Locate the soft rubber seal
    on the bottom of the cartridge.Fill holes
  2. Remove the cap from the
    correct color ink bottle and
    insert the needle NO MORE
    than 1/2 inch through the
    seal and into the cartridge.
  3. DO NOT to puncture the
    bladder inside the cartridge.
  4. DO NOT inject any air into
    the cartridge. If air does enter
    the cartridge, suck it out
    with the ink bottle.
  5. VERY SLOWLY squeeze the
    bottle injecting ink into the
  7. Replace the cap on the ink bottle and blot away excess ink.
  8. Install in printer

    NOTE: Each cartridge holds two colors, a base color and a photo color. The S020143 is magenta/light magenta and the S020147 is cyan/light cyan.



To use the syringe and needle in the kit:

  • Lock the needle into the syringe with a twisting motion.
  • Remove the ink bottle cap.
  • Insert the needle through the bottle seal.
  • Draw the ink up into the syringe.
  • Insert the needle into the inkjet cartridge. SLOWLY push the syringe plunger down to inject the ink into the cartridge.
  • Inject any excess ink in the syringe back into the ink bottle.
  • Rinse the syringe and needle with warm water after use to prepare the syringe for the next color.

Please review before attempting refill procedure

  • Ink bottles have a dot label on the bottle identifying the color.
  • Work in a suitable area so that any spillage or drips are contained.
  • Ink is permanent and will stain clothing, etc.
  • Read the complete instructions for your cartridge before beginning the refill procedure.
  • Do NOT touch any of the electronic contacts of the cartridges.
  • Do NOT let ink cartridge dry out. 
  • Refill the cartridge immediately after removal from the printer.
  • Inject ink very slowly to avoid injecting air bubbles. Do NOT overfill.
  • Always recap partially used ink bottles for storage.
  • Exposure to air for long periods of time will cause the ink to deteriorate.
  • If cartridge leaks after refilling, let the cartridge stand in an upright position for 5 minutes on a dry paper towel.
  • Immediately install the refilled cartridge in the printer.
  • More than one cleaning or printing cycle may be required for some cartridges.