Jump to:

HOME

INDEX

General Instructions

Cleaning Solution Instructions

Chip Resetter

Tools required:

Buy this cartridge rather than refill it.
  1. Seal each feed hole on the bottom with
    adhesive tape. This tape will remain in
    place after filling.Feed holes
  2. Over the empty reservoir near the back of the cartridge, drill a breather hole with the
    drill.
  3. Locate the depression under the label in the center of each color chamber and make a fill hole with the eyescrew.
  4. Remove the cap from the correct color ink bottle and insertFill holes - colors the needle through the fill hole.
  5. SLOWLY squeeze the bottle injecting ink into the cartridge.
    Rest one minute and repeat.
  6. DO NOT OVERFILL.
  7. Replace the cap on the ink bottle and blot away excess ink.
  8. Make an airtight seal on the
    breather holes and the fill holes with good adhesive tape.
  9. DO NOT remove the tape from feed holes on the bottom.
  10. Install in the printer.

 


GENERAL INSTRUCTIONS (Please Read!)

To use the syringe and needle in the kit:

  • Lock the needle into the syringe with a twisting motion.
  • Remove the ink bottle cap.
  • Insert the needle through the bottle seal.
  • Draw the ink up into the syringe.
  • Insert the needle into the inkjet cartridge. SLOWLY push the syringe plunger down to inject the ink into the cartridge.
  • Inject any excess ink in the syringe back into the ink bottle.
  • Rinse the syringe and needle with warm water after use to prepare the syringe for the next color.
  • DO NOT MIX COLORS IN THE SYRINGE.

Please review before attempting refill procedure

  • Ink bottles have a dot label on the bottle identifying the color.
  • Work in a suitable area so that any spillage or drips are contained.
  • Ink is permanent and will stain clothing, etc.
  • Read the complete instructions for your cartridge before beginning the refill procedure.
  • Do NOT touch any of the electronic contacts of the cartridges.
  • Do NOT let ink cartridge dry out. 
  • Refill the cartridge immediately after removal from the printer.
  • Inject ink very slowly to avoid injecting air bubbles. Do NOT overfill.
  • Always recap partially used ink bottles for storage.
  • Exposure to air for long periods of time will cause the ink to deteriorate.
  • If cartridge leaks after refilling, let the cartridge stand in an upright position for 5 minutes on a dry paper towel.
  • Immediately install the refilled cartridge in the printer.
  • More than one cleaning or printing cycle may be required for some cartridges.