Jump to:

HOME

INDEX

General Instructions

Cleaning Solution Instructions

Chip Resetter

Tools required:

Buy this cartridge rather than refill it.
  1. Peel back the label at the “PUSH”Peel back the label
    arrow to expose the vent holes in the top of the cartridge.
  2. Using the drill, make a fill hole through the vent hole for each color.
  3. Remove the cap from the correct color ink bottle and insert the needle through the fill hole.
  4. SLOWLY squeeze the bottle injecting ink into the cartridge.
  5. DO NOT OVERFILL.
  6. Replace the cap on the ink bottlePeel back the color label
    and blot away excess ink.
  7. Reseal the holes with the label.
  8. Install in the printer.

    Note: The BCI‐61 will stop printing when one color runs out, so the other colors will probably not be empty. Fill
    them all carefully and LOWLY each time you refill.

 


GENERAL INSTRUCTIONS (Please Read!)

To use the syringe and needle in the kit:

  • Lock the needle into the syringe with a twisting motion.
  • Remove the ink bottle cap.
  • Insert the needle through the bottle seal.
  • Draw the ink up into the syringe.
  • Insert the needle into the inkjet cartridge. SLOWLY push the syringe plunger down to inject the ink into the cartridge.
  • Inject any excess ink in the syringe back into the ink bottle.
  • Rinse the syringe and needle with warm water after use to prepare the syringe for the next color.
  • DO NOT MIX COLORS IN THE SYRINGE.

Please review before attempting refill procedure

  • Ink bottles have a dot label on the bottle identifying the color.
  • Work in a suitable area so that any spillage or drips are contained.
  • Ink is permanent and will stain clothing, etc.
  • Read the complete instructions for your cartridge before beginning the refill procedure.
  • Do NOT touch any of the electronic contacts of the cartridges.
  • Do NOT let ink cartridge dry out. 
  • Refill the cartridge immediately after removal from the printer.
  • Inject ink very slowly to avoid injecting air bubbles. Do NOT overfill.
  • Always recap partially used ink bottles for storage.
  • Exposure to air for long periods of time will cause the ink to deteriorate.
  • If cartridge leaks after refilling, let the cartridge stand in an upright position for 5 minutes on a dry paper towel.
  • Immediately install the refilled cartridge in the printer.
  • More than one cleaning or printing cycle may be required for some cartridges.